Fault Description:

1. Filament break detection module false alarm.
2. Filament break detection module failure (not working).

Steps for Removing the Filament Detection Module:

1. Prepare the Printer:
   1. Turn on the M5 switch.
   2. Click Control > Move on the screen to raise the Z-axis of the nozzle assembly by 200mm and move it to the middle of the X-axis for easy replacement.

• Make sure the filament is removed and turn off the power. Wait for the hotend to cool down for easy replacement.

 

Remove Left Shoulder Back Cover:

• Use an H2.0 hex wrench to unscrew the upper bolt at the left shoulder back cover and the bottom two bolts at the left shoulder.

Left button back cover

Bottom of left shoulder

Open Left Shoulder Upper Cover:

• In the upper part of the left shoulder, open the upper cover from the back to the front.
• Unplug the filament detection wire.

Remove Filament Detection Module:

• Use the H2.0 hex wrench to unscrew the two long bolts on the filament detection module.
• Remove the filament detection module.

 

Installation Steps for Filament Detection Module:

1. Position New Filament Detection Module:
   1. Ensure the filament is removed.
   2. Place the new filament detection module in the fixed position (pay attention to the forward direction of the module socket).

Secure New Module:

• Use an H2.0 hex wrench to tighten the two long bolts on the filament detection module.
• Plug in the power cord.

Secure New Module:

• Use an H2.0 hex wrench to tighten the two long bolts on the filament detection module.
• Plug in the power cord.

 

Reattach Left Shoulder Cover:

• Install the upper cover of the left shoulder.
• Use an H2.0 hex wrench to tighten the upper bolt and the bottom two bolts of the left shoulder.

Check Installation:

• Load the filament.
• Click Control > Extrude > Load on the screen to check if the filament detection module is installed and if the M5 can run normally.

By following these steps, you can successfully replace the filament detection module on your AnkerMake M5 printer. If you have any questions, please contact us for assistance.