Identifying Issues:

1. Camera light fails to turn on.
2. Camera doesn't stream.

Method of Replacement:

1. Remove the Right Shoulder Shell Back Cover:
   1. Use an H2.0 hex wrench to remove the three bolts on the back cover and the two bolts at the bottom front end of the M5's right shoulder shell.

Remove the Right Shoulder Rear Housing Cover:

• Use an H2.0 hex wrench to remove the four bolts that fix the front housing of the right shoulder internally.

Disconnect Wires:

• Use an H2.0 hex wrench to remove the ground wire connection bolts, the two TYPE-C wire bolts, and pull out the TYPE-C wire.

Remove the Display Screen Decorative Cover:

• Unplug the camera LED light cable and push the buckle forward to remove the camera cable.

1. Disconnect Additional Wires:

• Remove the X-axis motor wire and FCC cable, then remove the display cover.

Remove the Camera Module:

• Use an H2.0 hex wrench to remove the camera fixing bolt and take out the camera module.

1. Install the New Camera Module:
   1. Push the new camera module into position along the card slot and use an H2.0 hex wrench to fix the camera module bolt.
2. Reconnect Wires:
   1. Plug in the camera module LED cable, camera cable, X-axis motor cable, and FCC cable.
3. Reconnect the TYPE-C Wire:
   1. Insert the TYPE-C wire and install the TYPE-C wire fastening bolts with an H2.0 hex wrench.
4. Secure the Ground Wire Connection Bolt:
   1. Use an H2.0 hex wrench to fix the ground wire connection bolt and install the display front decorative cover.
5. Reinstall the Front Cover:
   1. Use an H2.0 hex wrench to install the front cover and the screen cover screws.
6. Reinstall the Right Shoulder Back Cover:
   1. Use an H2.0 hex wrench to lock the right shoulder back cover and bottom housing screws to complete the camera module replacement.

If you encounter any issues or need further assistance, please contact AnkerMake customer support at us.