Features and description

The model surface is uneven

Reasons, Diagnoses, and Solutions

Inadequate Infill Leads to Model Surface Collapse

• Diagnosis: Preview the model Gcode and check whether there is Support at the collapsed position.
• Solution: Increase printing temperature, increase infill density, or replace the infill pattern.

Printing Process Interruption Causes Spots or Scars on the Surface of the Model

A. Power Cut Off During Printing Process

• Diagnosis: Check whether the power was cut off during the model printing process and manually click to continue.
• Solution: Cut/sand the scar or reprint the model.

B. Midway Pause

• Diagnosis: Check whether the printing was paused during the model printing process and manually clicked to continue. If the nozzle stays in the upper left corner of the printing platform for an extended period, filament leakage due to gravity may form spots on the model when continuing to print.
• Solution: Remove the leaked part of the filament and continue printing.

C. Break Detection Alarm

• Diagnosis: Check whether there was a material break alarm during the model printing process, reload the filament, and manually click to continue. If the nozzle stays in the upper left corner of the printing platform for an extended period, filament leakage due to gravity may form spots on the model when continuing to print.
• Solution: Remove the leaked part of the filament and continue printing.

If none of the above methods can solve the problem, please contact us directly through us and provide logs (APP side through Me > About > Upload Log, device side through Setting > Upload Log), Gcode, STL model and phenomenon pictures for analysis.