When you notice a spaghetti effect in the print model, as shown below, try these steps:

1. Check the placement of the filament holder. It is recommended to install it in the lower left corner and turn it clockwise to reduce resistance when the filament is pulled in and to avoid defects caused by insufficient tension.
2. If the position of the print model is inconsistent with that in the slicer and displacement occurs, please refer to the troubleshooting steps for “The initial layer is not sticking.” Additionally, strengthen the support of the weak parts of the model (such as suspended surfaces/bridges) to avoid nozzle collisions during printing caused by model warping.

If you have any further questions, please contact AnkerMake Customer Support for assistance.