Small details on the model cannot be printed, as shown in the blue part in the figure below
Reasons, Diagnoses, and Solutions
Printing Thin Walls and Resolution Are Not Set correctly, Preventing Printing Details Smaller Than the Diameter of the Nozzle.
Diagnosis: Check Expert > Quality > Resolution to see if the maximum resolution parameter in the studio is the recommended 0.1 mm.
Solution: Reduce the maximum resolution to allow AnkerMake Studio to recognize more details. Enable the "Detect Thin Wall" function through Expert > Strength > Detect Thin Wall.
The Detail Size is Too Small to Print
Solution: Replace the nozzle with one of a smaller diameter and reduce the layer thickness. (Generally, the layer thickness should not exceed 80% of the nozzle diameter.) After heating the nozzle to 180°C, replace it with a socket wrench. Refer to the following resources for detailed instructions:
If none of the above methods can solve the problem, please contact us directly through us and provide logs (APP side through Me > About > Upload Log, device side through Setting > Upload Log), Gcode, STL model and phenomenon pictures for analysis.
