Features and description

Gaps appear in the thin-walled sections of the model, primarily because the wall thickness is not an integer multiple of the line width.

Reasons, Diagnoses, and Solutions

1. Improper Use of Wall Parameters (not applicable in Simple Mode):
   1. Diagnosis: Open Expert > Quality, and check if the "Wall generator" parameter is set to Arachne (variable linewidth).
   2. Solution: Switch the "Wall generator" parameter to Arachne (variable linewidth).

1. Thin Wall (Line Width) to be Printed is Smaller Than the Nozzle Diameter:
   1. Solution: Replace the nozzle with a smaller diameter to print the thin-walled workpiece. After heating the nozzle to 180°C, use an M6 socket and hexagonal wrench to replace the nozzle. Refer to the following resources for detailed instructions:
      • Article: How to Replace the Nozzle for the M5C Printer

If none of the above methods can solve the problem, please contact us directly through us and provide logs (APP side through Me > About > Upload Log, device side through Setting > Upload Log), Gcode, STL model, and photos of the issue for analysis.