Assembling the Printer
4. Assembling the Printer
4.1 Installing Gantry Frame
What You Need
1.Open the box, then place the foam cover (A) on a flat, stable surface.
2.Take out all the accessories in the foam (B), then place the foam (B) next to the foam cover (A) as support.
3.Take out the gantry frame with its packaging foam (C) and place it on the foam (B).
4.Move the gantry frame as shown below.
5. Detach the bottom cover from the platform.
6.Route the USB-C cables through the holes, then insert the two supports of the gantry frame into the base holes.
7.Fasten 8 screws into the platform to firmly fix the gantry frame.
4.2 Wiring
What You Need
1.Connect the motor wires and make sure that the connector's pin side is facing outside.
2.Connect and secure the USB-C cables with screws.
- Make sure to firmly secure the USB-C cables with screws.
3.Put the bottom cover back onto the platform.
4.3 Installing Filament Holder
What You Need
Secure the filament holder with screws.
4.4 Connecting to Power
What You Need
1.Check the voltage (115V for the USA, Canada and Japan or 230V for the EU) and remove the foam from the platform.
Visit https://support.ankermake.com/s/ to learn how to switch voltages
2.Connect the printer to a power outlet with the power cord, then switch on the printer. The power light will turn steady red.
3.Follow instructions on the touch screen to complete the initial setup.
119 undefined
M5C X Axis Belt Adjuster.gcode
Ankermake Studio Guide(V1.5.21)
M5C Y axis belt adjuster.gcode
V8110 AnkerMake M5C EU Declaration of Conformity
V8110_UK Declaration of Conformity
M5C Y Axis Belt Adjuster.gcode
View More
How to Replace the Air Guide of the Print Model Fan
How to Replace the Print Model Fan
Auto Leveling
V Wheel Adjustment
How to Transfer Files and Start Printing
Loading Filament
View More
