The gap between the model infill and the inner wall.
Reasons, judgments, and solutions
Improper Slice Parameter Settings (No Need to Consider When Using Simple Mode)
Diagnosis: Check whether the infill width is the recommended value of 0.4 mm by going to the quality section in the settings menu.
Solution: When the infill width is 0.4 mm, if there is still a gap, the infill overlap percentage can be appropriately increased by going to Strength > Infill/Wall Overlap. It is generally not recommended to exceed 50%.
If none of the above methods can solve the problem, please contact us directly through us and provide logs (APP side through Me > About > Upload Log, device side through Setting > Upload Log), Gcode, STL model and phenomenon pictures for analysis.
