Exhaust Fan Kit and Purifier P1 are ventilation and purification accessories for the eufyMake E1 (V8260) UV Printer.
Q1: What do these two accessories do?
During printing, the UV printer produces gases and odors, which can accumulate over time in enclosed or semi-enclosed spaces. Exhaust Fan Kit vents the gases outdoors through an exhaust duct, while Purifier P1 circulates and filters the air indoors. Both help improve the air quality and comfort of the printing environment.
Q2: The ink is non-toxic, so why do I still need ventilation or filtration?
The ink is GREENGUARD certified. However, users' workspaces and ventilation conditions vary, as does their sensitivity to odors produced during printing. You can choose ventilation or purification equipment based on your actual needs.
Q3: How effective are the odor-removal and purification functions? Is there a test report?
Under the official test standard, when Exhaust Fan Kit is used for continuous printing for 8 hours in a 30 m² semi-enclosed space at maximum exhaust power, the peak TVOC increase in the exhausted air at a distance of 1 m from the device is below 0.8 mg/m³.
Purifier P1 is certified by an SGS laboratory. Its TVOC removal rate is up to 99.54%, and it captures 99.97% of 0.3 μm dust particles and 99.99% of PM2.5, reaching laboratory-grade purification standards.
Q4: How loud is it during operation? How does it compare with other air purifiers?
Purifier P1 produces no more than 55 dB of noise at high speed and no more than 45 dB in silent mode. Exhaust Fan Kit produces no more than 50 dB at high speed and no more than 40 dB in silent mode, providing quiet and unobtrusive operation.
Q5: What is the difference between Exhaust Fan Kit and Purifier P1 ? How do I choose?
Exhaust Fan Kit vents gases outdoors through an exhaust duct, so it requires a window or vent. Purifier P1 circulates and filters the air indoors and does not need to be connected to the outside.
Choose Exhaust Fan Kit if you have a window or an opening to the outside. Choose Purifier P1 for fully enclosed, windowless spaces.
Q6: Do I need to connect to the app to use it?
Purifier P1 does not require the app and can be operated using the buttons on the unit. After connecting it to the app, you can remotely control the unit, link it with the printer for automatic start/stop, and check the remaining filter life.
Exhaust Fan Kit is controlled entirely using buttons and does not require network configuration.
Q7: After installing Exhaust Fan Kit, do I still need to replace the original air filter box?
No. After installing Exhaust Fan Kit, printing gases are vented outdoors mainly through the exhaust duct. The original air filter box should be removed when installing the accessory and no longer needs to be replaced.
Q8: In what weather conditions is Exhaust Fan Kit not recommended for use?
Do not use it in high winds or rain, as this may cause rainwater backflow and reduce exhaust effectiveness.
Q9: How long does the Purifier P1 filter last in different modes?
Approximately 1,700 hours in silent mode, 540 hours in high-speed mode, and 300 hours in full-power mode. Filter life varies depending on usage intensity. Refer to the remaining filter life shown in the app.
Q10: How do I replace the Purifier P1 filter?
The remaining filter life is displayed as a percentage in the app. A replacement prompt appears when it drops to 15%. After replacing the filter, the device automatically recognizes the new filter and displays its new life.
Q11: Does the hose have a warranty?
The hose is a consumable accessory and is not covered by the warranty. It has no fixed replacement interval. Replace it as needed based on its level of wear or if it becomes cracked.
