We have summarized a list of frequently asked questions regarding the AnkerMake M5 filaments from our valued customers.

1. What type of consumables do AnkerMake M5 and M5C support?

AnkerMake M5 and M5C support AnkerMake official PLA+, PLA+ Basic, PLA+ Matte, PLA+ Silk, PLA+ Glitter, PLA+ Metalic, PETG, TPU, and ABS filaments. The nozzle temperature of M5C can reach up to 300℃, which further supports the printing of high-performance materials such as PA, PC, PET-CF, and PA-CF.

2. Can I use other consumables with AnkerMake M5 and M5C?

Generally, it is recommended to use official AnkerMake materials. The main reason is that all parameters (such as temperature, cooling power, printing speed, etc.) set in the AnkerMake Slicer software are optimized for different types of AnkerMake branded consumables. If you have other requirements, you can also use third-party filaments with a diameter of 1.75 mm, but we cannot guarantee the printing quality and performance.
 

3. Are the products printed with PLA+ filament food safe?

PLA+ materials comply with RoHS Directive 2011/65/EU and (EU) 2015/863 as well as REACH regulations, which means they do not contain toxic or harmful substances. However, PLA+ printed products have horizontal layer lines. Bacteria can easily grow in these horizontal layer line gaps, therefore, it is not recommended to use printed products for food-related applications.

4. What is the correct way to store consumables?

We recommend storing unopened materials in a clean, cool, dry, ventilated, and dark place, with an environmental temperature below 40°C and relative humidity below 30%. We recommend storing unused filament in vacuum bags or drying boxes. If the unused filament has been exposed for a long time, it is strongly recommended to dry it before use.
 

5. Recommendations for filament drying conditions:
 

6. What do wet filaments look like?

Here are some signs that the filament may have become wet:

• Filaments break easily when they are bent or pulled.
• Filaments emit a popping sound when they are squeezed.
• The first layer of the print model has poor adhesion.

When filaments are not sealed and left in the open, they will absorb moisture in the air and become wet, especially when filaments are made of either PETG or TPU. It is important to note that wet filaments may greatly reduce the print quality. It is highly recommended to store the filaments in vacuum bags so they are not exposed to moisture in the air, or dry the wet filaments before using them to print.
 

If you have any further questions, please contact us for assistance.